Super Ego SEH025100 Guia De Inicio Rapido página 5

GB Instructions for use
5. Make sure that the cartridge to be replaced is
completely empty before inserting a new one.
6. Check carefully the seals before inserting a new
cartridge in the device.
7. Turn the lower part of the cartridge lighter and
remove the empty cartridge [Fig.2].
8. Insert the gas cartridge and screw completely
the cartridge retainer [Fig.3].
B) IGNITION OF THE WELDER:
1. Make sure that no gas is leaking.
2. Press the red button after opening the gas knob.
3. To regulate the intensity of the flame, open or
close slightly the gas regulator (+/-).
4. A flare may appear during the heating process or
if the device is shaken.
C) TURNING OFF THE DEVICE:
To turn off the welder, the gas knob must be
completely closed. After using the device, wait until
the welder has cooled off completely cold.
D) FLOW ADJUSTMENT [Fig.4]
DANGER:
Some of the exposed parts may be very hot. Keep
children away from this device.
5
OPEN CLOSE