C/ Model - Gpa15 - Absaar AB100-1204 GPS4 Manual De Usuario

ENG

C/ Model - GPA15

IMPORTANT
The ABSAAR GPA15 is an ''AUTOMATIC'' charger, which means you do not need
to manually disconnect it once the battery is fully charged. You can leave the char-
ger connected to the battery and the charger will automatically stop the charging
process once the battery is fully charged. It will also resume charging automatically
once the battery needs charging.
2 3 4 5
7
6
1. Charging current selector
Red light indicates: Charging in progress
Red light indicates: Load current 6A
Red light indicates: Load current 10A
Red light indicates: Load current 15A
6. Voltmeter.
7. Red light indicates: 12V 8 9
1
8. Red light indicates: 24V
9. Green light indicates: [Green light indicates:] Battery fully charged
Charging the battery:
1- Connect the battery to the charger following the connection procedure.
NOTE: Battery voltage is selected automatically by the charger. If the battery is
discharged or defective, there is a possibility of an automatic selection error, for
example, if a 24-volt battery with a deep discharge has been mistaken for a 12-volt
battery. Should this be the case, test the battery and/or use a STANDARD charger
to run a "forced" charge. You can check the battery voltage on the voltmeter (6) at
all times.
2- Using the charging current selector (1), select the desired charging current
6A/10A/15A depending on the charging speed and the capacity of the battery. The
desired option is displayed on the LED indicators 3/4/5.
3- Once the battery is fully charged, the green LED indicator (9) will light up, indicating
that the battery is now fully charged and will stop the charging automatically.
4- You can leave the battery connected to the charger. It will set off the charging auto-
matically when required.
vers.3
Page 9