Vetus SMTO2S Instrucciones De Instalación Y Manual De Manejo página 6

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 18
1 Introduction
The Vetus 'SMTO2S' and 'WCPS' toilets are marine toilets with
an integrated pump system. With correct installation and opera-
tion, these toilets function like a normal toilet.
These Vetus toilets may only be used for pumping and
removal of faeces and toilet paper.
These toilet are not suitable for pumping other objects
such as cotton wool pads, tampons, sanitary towels, con-
doms or hair, or for pumping out fluids like oil. This could
cause damage!
Always make sure you have a pair of rubber gloves on board.
2 Safety
Ensure that the power supply is switched off during mainte-
nance or repairs.
Never put your hands in the hole in the toilet bowl. The blades
are not covered!
3 items supplied
A
toilet
B
toilet seat
C
set of fasteners for the toilet
D
set of fasteners for the toilet seat
E
hose clamps
F
reduction piece
6
110132.02
Note!
1x
1x
1x
1x
2x
1x
4 Installation
4.1 General
See Page 26 for installation examples.
Always install the toilet in accordance with the applicable regu-
lations of the country concerned. In some areas, it may not be
permitted to pump waste straight from the toilet into the water!
4.2 Fitting the toilet to the floor
Always mount the toilet on a sufficiently strong floor to prevent
the occurrence of point loads and the toilet bowl splitting. If
necessary fit an extra sheet of multiplex under the floor to rein-
force it.
• Place the toilet in the position required.
• Determine the position of the fitting holes. Use the toilet as a
template for this.
• Fit the toilet with the screws supplied.
• Attach the toilet using the fasteners supplied.
A
SMTO2S
WCPS
B
C
B
A
C
Electric marine toilet SMTO2S - WCPS

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Wcps

Tabla de contenido