Charge Your Headset - KlipXtreme AthletikX Manual Del Usario

III- Basic operation

Charge your headset

• Plug the supplied USB cable into the USB
port of your computer or to a 5V USB
adapter to charge the battery.
• Connect the micro-USB end of the cable into
the charging port of the headset.
• Make sure that your headset is fully charged
before using it for the first time.
• The headset battery has to be initially charged
for at least 3 hours. Thereafter, the battery
will take around 2 hours to recharge.
• While the headset is being charged, the LED
glows red. The status light turns solid blue
once it has reached full capacity.
Turning your headset on and off
Press and hold the power button for 4
1.
seconds to turn the earphones on. The blue
LED indicator will glow and an audible tone
will be heard.
To power off the device, press and hold the
2.
power button again for 6 seconds. The red
LED indicator will glow and another audible
tone will be heard.
IV- Advanced operation
Note: Before installing this product, please
make sure your device has the built-in
Bluetooth feature available. If your device is
®
not Bluetooth -enabled, you must purchase a
®
Bluetooth receiver.
Pairing the earphones with your
mobile device
Place both devices not more than one
1.
meter away from each other.
Set your Bluetooth
2.
®
wireless headset.
Press and hold the power button for a few
3.
seconds to turn the headset on and to put it
into the pairing mode.
An audible tone will be heard, accompanied
4.
by alternating blue and red LEDs, to indicate
that the headset has entered into the pairing
mode.
On your mobile phone, tap the newly
5.
discovered audio device (KHS-634)
displayed in the Bluetooth
When the phone asks if you want to pair
6.
phone to "discover" the
list.
®