Du Pont WFHD13001 Serie Instrucciones De Instalación página 5

STEP 3
ssemble the System and Install Optional Mounting Bracket
1
Dry assemble the complete system (according to the configuration chosen), including all fittings and valves.
2
When installing the optional mounting bracket (not included), position it on top of the System Head
with the holes in the System Head. Insert four mounting screws (not included) through the mounting bracket and into the holes of
the System Head until tight.
3
Measure the overall length (see diagram) of the configured system.
4
Reduce this measurement enough to allow for the amount of engagement (X) to determine how much pipe to remove from the line.
STEP 4
Mark Measurements and Cut the Plumbing Pipe
C UTION
Please wear safety glasses to protect
eyes when cutting.
1
Mark the section of the plumbing pipe that will need to be removed to allow for the configured system (as determined in Step 3).
NOTE: Measure twice, cut once!
2
Using a pipe cutter or hacksaw, cut the marked section from the plumbing pipe.
NOTE: Use a pan or bucket to catch any remaining water in the pipes.
3
Remove any burrs or debris from the cut edges with a file.
WFHD13001 Series
3
, aligning the bracket holes
4
4
Mounting Screws
(not included)
2
Mounting Bracket
(not included)
3
4
X
SEE CH RT
P GE 3
V4.0