Checking The Engine Oil Level; Changing The Engine Oil - PEUGEOT SCOOTERS TWEET Manual De Utilización

CHECKING THE ENGINE OIL LEVEL

Too much oil will noticeably restrict the
vehicle's performance.
B
A
• Place the vehicle on its central stand on flat ground.
• Remove the engine's oil filler cap/gauge.
• Wipe the cap/gauge and reinsert it into the filling
orifice without screwing it up.
• Remove the filler cap/gauge and check the oil level.
• The oil level shall not be between the minimum (A) and
maximum (B) level marks without exceeding the latter.
• Add oil if necessary.

CHANGING THE ENGINE OIL

We advise you to go to a registered
dealer for draining.
Oil contains substances which are
harmful to the environment. Your dealer
is equipped to dispose of used oil
without endangering the environment
and in
standards.
SAE 10W30 Synthetic API SL/SJ
SAE 5W40 Synthetic API SL/SJ
SAE 15W50 Synthetic API SL/SJ
0.95 l at oïl change
When the ambient temperature is below -10 °C, use
an oil of viscosity: 5W40
°C
-30 -20 -10
°F
-22 -4
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Scooters
compliance with current
Engine oil
Quantity
5 W 40
10 W 30
10 W 40 15 W 50
0 10 20 30 40
14 32 60 68 86 104
The engine must be drained when it is warm to allow the
oil to run easier.
1
• Place the vehicle on its central stand on flat ground.
• Put on protective gloves.
• Remove the drainage cap and its seal (1) and allow the
oil to drip into a recipient.
3
• Remove the strainer cap (2) and clean the strainer (3).
• Put back the drainage cap and strainer cap, fitted with
a new seal.
• Pour the required quantity of oil corresponding to the
manufacturer's standards into the filler hole.
• Start the engine and let it run for a short while.
• Add oil if necessary.
• Check that the oil drain plug is sealed.
FR
GB
DE
IT
ES
NL
2
GR
SE
PT
FI
DK
13/18