Carton Contents - sunjoe SPX2005P Manual Del Operador

Unpacking

Carton Contents

• Electric pressure washer
• Transport handle
• Trigger gun
• Quick-Connect spray wand
• Three (3) Quick-Connect nozzles (0º, 15º, and 40º)
• Foam cannon (SPX-FC26)
• Two (2) large Phillips head screws (for handle)
• Trigger gun holder
• High-pressure hose/cord holder
• Rear compartment
• Two (2) small Phillips head screws (for rear compartment)
• Needle clean-out tool (included with manual packet)
• High-pressure hose
• Two (2) wheels
• Dual-nozzle rotating surface cleaner (SPX-PCA10)
• Surface cleaner attachment
• Surface cleaner extension wand
• Dual-nozzle rotating sprayer
• Garden hose adapter (female coupler)
• Manual with registration card
1. Carefully remove the pressure washer and check to see
that all of the above items are supplied.
2. Inspect the product carefully to make sure no breakage or
damage occurred during shipping. If you find damaged or
missing parts, DO NOT return the unit to the store. Please
call the Snow Joe + Sun Joe
®
1-866-SNOWJOE (1-866-766-9563).
NOTE: Do not discard the shipping carton and packaging
material until you are ready to use your new electric
pressure washer. The packaging is made of recyclable
materials. Properly dispose of these materials in
accordance with local regulations.
IMPORTANT! The equipment and packaging material are
not toys. Do not let children play with plastic bags, foils,
or small parts. These items can be swallowed and pose a
suffocation risk!
m
WARNING!
Do not connect to power supply until
assembly is complete. Failure to comply could result in
accidental starting and possible serious personal injury.
customer service center at
®
Assembly
Tools required: Phillips head screwdriver
1. Lay unit on its side. Firmly press the wheel onto the unit
body until it locks into place. Repeat on the opposite side
(Fig. 1).
Fig. 1
2. Following the alignment grooves at the top of the machine
body, slide the handle into position from the front to the
back, so that the solid side of the handle faces the front
of the washer. Secure the handle using a Phillips head
screwdriver and the two (2) supplied large Phillips head
screws (Fig. 2).
Fig. 2
Handle
7
Wheel
Large Phillips
head screws
Alignment
grooves