Installation; Connection-Wire Diagram; Test - Temper KOBAN KDP-8MW Manual De Usuario

KDP-8MW
Microwave Sensor
INSTALLATION: (see the diagram)
--Unload the faceplate of sensor and adjust the time, LUX and ON/AUTO/OFF knobs.
(refer to figure 1)
--Loose the screws in the connection terminal, and then connect the power to connection
terminal of sensor according to connection-wire diagram.
--If you want to install it in circular hole, put the sensor into the hole and tighten the splay
bolt on both sides (refer to figure 2). If you want to install in quadrate hole, put the
sensor into the hole, fix the screw through the mounting hole (refer to figure 3).
--Install back the faceplate, switch on the power and then test it.
Figure 1

CONNECTION-WIRE DIAGRAM:

--The detector has a selector switch
which can vary between ON/OFF/AUTO position.
*ON: The load is connected permanently.
*OFF: The load is turned off permanently.
*AUTO: The load is connected depending on the presence.

TEST:

--Turn the LUX knob clockwise on the maximum (sun).
Turn the SENS knob clockwise on the maximum (+).Turn
the TIME knob anti-clockwise on the minimum (10s).
14
Figure 2 Figure 3
www.grupotemper.com