Osborne RN3 Serie Instrucciones De Armado Y Operación página 3

D
13. Place completed assembly into feeder hopper. Align cone onto axle as-
sembly.
T
H
15. Place feed flow control onto crossbar with back side of assembly resting
against flat side of crossbar. Install the feed flow control to crossbar with
5/16 x 7/8-in. bolt and 5/16-in. flange nut.
P
17. Slide feed flow control spring onto bolt from the bottom up. Thread nuts
(C & D) behind it.
Spring
19. Place bump bar agitators (Items 21) into the two middle holes on the
crossbar. Install washers and nuts (Items 22). Adjust length of bump bars
with the nut. Use pliers to hold the bump bars in place. When the wheel
is turned, the bump bars should only drag along the hopper bottom about
one-fourth of a full circle.
To train pigs on the feeder, set feed flow control to 1 1/2 to 2 and manually turn feed wheel until feed begins to flow into trough. Manually scoop feed into the
trough and fill for first use. As first trough full is eaten, pigs learn through play that the feed wheel dispenses feed. Adjust the cone height with feed flow control
WARNING: WHEN FEEDER IS IN USE, DO NOT ADJUST FEED FLOW CONTROL ABOVE POSITION 3 OR CONE MAY DISENGAGE AXLE.
D
T
H
C
D
N
ADJUSTMENT AND TRAINING RECOMMENDATIONS
as needed. Proper adjustment will vary based upon feed grind, moisture content and animal size.
14. Ensure feed flow control (Item 13) is set to '0'. Remove bottom two (2)
nuts and spring and set aside.
16. Connect feed flow control and cone strap. Hold cone strap upwards
against nut on feed flow control (A), and adjust nut (A) until cone is lightly
resting on center tube on feed sweep. Tighten second nut (B) against nut
(A).
18. While holding a wrench on nut (A), tighten nut (C) to tension the spring to
a length of 3.5-in. Tighten nut (D) against nut (C).
NOTE: Refer to ADJUSTMENT RECOMMENDATIONS below to set the
recommended cone height to start pigs.
O
20. Install fiberglass hopper lid (Item 24) by aligning indentions in lid with
crossbar. Attach hook and spring to crossbar to secure.
M
L
L
N
B
A
Hold cone strap up
A
3.5 in.
C
D
OPTIONAL LID INSTALLATION
SECTION P-P
R