Connections To Be Made - Axxess AX-ADFD01 Instrucciones De Instalación

FROM ThE 16-pIN haRNESS
16-pin harness to the aftermarket radio:
• Connect the White wire to the left front positive speaker output.
• Connect the White/Black wire to the left front negative speaker output.
• Connect the Gray wire to the right front positive speaker output.
• Connect the Gray/Black wire to the right front negative speaker output.
Only make the following connections if the vehicle contains the SONY/THX
amplified system.
• Connect the Green wire to the left rear positive speaker output.
• Connect the Green/Black wire to the left rear negative speaker output.
• Connect the purple wire to the right rear positive speaker output.
• Connect the purple/Black wire to the right rear negative speaker output.
FROM ThE aX-aDFD01 haRNESS:
(a) 22-pin harness to the aftermarket radio:
The DIN plug is to be connected to the optional AX-LCD screen (sold separately) if
SYNC information is shown on the OE radio.
• Connect the Red wire to accessory power if the AX-LCD screen will be used.
For all other connections to the 16-pin harness, refer to the instructions included with
the interface.
AX-ADFD01

Connections to be made

(included with interface):
(b) 24-pin harness to the aftermarket radio:
• Connect the Black wire to the ground wire.
• Connect the Yellow wire to the battery wire.
• Connect the Blue wire to the antenna turn-on.
Only perform the following step for the Ford Expedition.
• Connect the Blue/White wire to the amp turn-on wire of the aftermarket radio
(if populated on factory side).
These wires are to be connected if the vehicle does not have the SONY/THX sound system
• Connect the purple wire to the right rear positive wire.
• Connect the purple/Black wire to the right rear negative wire.
• Connect the Green wire to the left rear positive wire.
• Connect the Green/Black wire to the left rear negative wire.
(c) 16-pin harness to the aftermarket radio:
• Connect the RCA jacks labeled "RSE/SYNC/SAT" to the audio AUX-IN jacks on the
aftermarket radio (if retaining rear seat entertainment, SYNC, or satellite radio).
Note: Most Ford radios have satellite radio built into the radio, so this feature is lost if so.
• Connect the RCA jacks labeled "From 3.5" to the audio AUX-IN jacks on the after-
market radio (if SYNC is not present).
(d) 8-pin harness to the aftermarket radio:
• If the vehicle is equipped with a factory subwoofer, connect the White RCA jack to
the sub out jack on the aftermarket radio.
• If the vehicle is equipped with a SONY/THX amp, connect the Red RCA jack to the
center channel out jack on the aftermarket radio/processor.
Note: If this jack is not present on the aftermarket radio, just leave be. Only the
center channel speaker will be lost.
2