Extra Features - Axxess AX-ADFD01 Instrucciones De Instalación

Installing the AX-ADFD01
With the key in the off position:
• Connect the 16-pin harness into the interface.
• Connect the AX-ADFD01 harness into the interface.
• With the key in the off position, connect the AX-ADFD01 harness into the vehicle.
• With all connections completed, reconnect the negative battery terminal.
Note: If using the ASWC-1, connect it after you initialize and test the AX-
ADFD01, with the key in the off position.
Initializing the AX-ADFD01
Attention: If the AX-ADFD01 loses power for any reason, the following step will
need to be performed again.
• Initialize the interface by turning the ignition on for 30 seconds, then turn the
ignition back off, then back on again.
audio Level adjustment (if equipped with a SONY/ThX amplifier)
• With the vehicle and radio turned on, turn the volume up 3/4 of the way.
• Locate the end of the Interface with the 16-pin harness with stripped leads.
• With a small screwdriver, adjust the potentiometer clockwise to raise the audio
level; counterclockwise to lower the audio level.
• Once at a desired level, the audio level adjustment is complete.
AX-ADFD01
SYNC, rear seat entertainment (RSE), satellite radio (SaT), and aUX-IN:
• If your vehicle comes equipped with SYNC, RSE, SAT, or AUX-IN, the AX-ADFD01
can retain these features.
Note: Most Ford radios have SAT built in, so this feature is lost if so.
• Change the source of the radio to AUX-IN; SYNC audio will play if SYNC has been
activated.
• Either the vehicles display, or the optional AX-LCD (sold separately) will display
the SYNC information.
• Listed below are the functions of the AX-LCD:
Arrow up—Channel up (only in SAT or USB mode)
Arrow down—Channel down (only in SAT or USB mode)
Enter—Selects current item on the screen
Return/ESC—Exits to the previous screen
• To access RSE, SAT, or AUX-IN, press and hold the MEDIA button on the steering
wheel for 2 seconds. This will switch to the next available source in your vehicle.
Each time the MEDIA button is pressed for 2 seconds the source will change. The
sequence of sources are SYNC/RSE/SAT/AUX-IN. To temporarily disable SYNC/
RSE/SAT/AUX-IN, press and hold the MEDIA button for 3 seconds. To turn it back
on, press the MEDIA button for 2 seconds. There will be a visual confirmation of
what source you are on from the factory screen, or the AX-LCD. This screen will
also provide SYNC and SAT information.
3

Extra Features