Reverberi KRISTAL WATER DIST Manual Del Usuario página 4

INSTRUCTION
Pour water into the stainless steel tank
Use hot/cold water to fill the tank and make sure that you do
not go beyond the full line. If you use hot water, you can
shorten the time needed to distil water.
Starting up
Secure the upper cover and plug the power cord into the
Body
socket on the body. Place the collection bottle and the
protective cover in a secure place and make sure they are
Power reset
levelled. Plug the main power cord into the wall outlet and
then turn the power switch to "I"(at first start-up, this button is
pre-set to the "on" position, so there is no need to switch it on
for the very first use).
You will start the process when turn the switch on and it will
shut off automatically at the end of the process. If you wish to
terminate the process, unplug the main power cord from the
outlet or turn the main power switch to "0". If you want to restart
distillation, turn the main power switch to "I" to start power.
A power supply is turned off automatically when distillation
is completed
Approximately an hour after you have turned on the power
switch, the distilled water begins to drip down into the
collection bottle. It takes 5-6 hours to distil four litre of water.
When the power supply is cut off, you may move onto the next
tank immediately.
Distilled water
For proper storage place the distilled water in the refrigerator in a
sealed container. Before use shake the bottle to aerate the water.