Reverberi KRISTAL WATER DIST Manual Del Usuario página 5

MAINTENANCE
Use household neutral detergent to clean the surface of the
body and keep it dry (the rubber cushion within the upper
cover is set with a specific direction; please do not remove it
on your own).
To clean the body
The interior of the stainless steel tank is smooth. Never use
abrasive cleaners on your distiller. After each cycle rinse the
inside of the boiling chamber with clean water. To remove
heavy deposits, use the distiller cleaner as follows:
1. Pour hot water into the stainless steel chamber until it
covers the deposits.
2. Pour one to four spoonfuls of cleaner (based on the
amount of deposits) into the tank.
3. Leave the upper cover off, plug in the main power plug,
and turn on the power reset to heat the stainless steel
tank until boiling.
4. Discard the water fifteen to twenty minutes later, then
wash the interior with clean water.
5. Repeat the process until the chamber is clean.
6. Small amounts of residue are harmless, and you can
continue to use it safely.
Cooling duct
If the condensing coil is clogged with dust, the efficiency of
distillation may be affected. To clean the condensing coil,
remove all three screws from the underside of the cover.
Use a tooth brush or a vacuum cleaner to remove the
accumulated dust.
Others
"Take care" do not immerse the motor in the water when you
are cleaning the cover. We recommend you regularly add a
little oil on the motor shaft to help maintain the motor in good
working order.
Residue
cleaner
Body