Stenner Pumps M128 Instrucciones

M128 SYSTEM START-UP INSTRUCTIONS
NOTICE: Before installing or servicing the pump and water meter, read the pump and water meter manuals for all safety information and
complete instructions. The equipment is designed for installation and service by properly trained personnel.
Wall Mount Bracket
8
5
Stenner Pump Company
3174 DeSalvo Road
Jacksonville, Florida 32246 USA
1. Select a dry location to mount panel to avoid water intrusion. When selecting the
location, note the water flow direction as indicated on the flow meter. Location
should allow mounting hardware to be anchored into studs or concrete to support
4
the weight of the panel.
2. Isolate and depressurize the water system.
3. Mark location of lag bolt holes 14 1/4" above center line of the horizontal pipe.
4. Secure wall mount bracket to wall studs using the included lag bolts or other suitable
hardware. Hang panel on to wall mount bracket.
5. For convenience, the panel has male hose thread connections on the inlet and outlet.
Using hose connectors, connect the inlet and outlet of the panel to the water system.
7
NOTE: The male hose thread adapters can be removed to provide 3/4" NPT connections
on the panel inlet and outlet if desired.
6. Cut necessary length of suction tubing and connect to the suction side of the pump
head which is the threaded fitting closest to the panel. Secure the weighted strainer
to one end and secure the tubing to the pump tube fitting with the provided nut
and ferrule. DO NOT use wrenches or thread seal tape. Connection needs to be
finger tightened.
7. Plug pump power cord into an appropriate receptacle as specified in the pump
instruction manual.
8. To prime the pump, depress the button on the rear of the pump and observe the
liquid being drawn from the solution tank. When it reaches the injection point release
the prime button.
9. Pressurize the system slowly, check for leaks, and verify pump operation.
Shocking the meter by over speeding it with high flow rates can damage the
internal assembly.
and downstream of the panel.
5
and electrical codes.
Limited Warranty: This warranty applies to the M128 panel system and mounting items only. The Pump is
covered under a separate warranty stated in the product manuals included. The component manufacturers'
warranties apply to the flow assembly parts such as meter, fittings, etc. Stenner Pump Company will for a
period of one (1) year from the date of purchase (proof of purchase required) repair or replace – at our
option – all defective parts. Stenner Pump Company is not responsible for any removal or installation costs.
Stenner Pump Company will incur shipping costs for warranty products shipped from our factory in
Jacksonville, Florida. Any tampering with major components, chemical damage, faulty wiring, weather
conditions, power surges, or products not used with reasonable care and maintained in accordance with the
instructions will void the warranty. Stenner Pump Company limits its liability solely to the cost of the original
product. We make no other warranty expressed or implied.
Disclaimer: The information contained in these instructions are not intended for specific application purposes.
Stenner Pump Company reserves the right to make changes to prices, products, and specifications at any time
without prior notice.
When pressurizing the system gradually allow water to flow.
Ensure the piping is properly aligned and supported both upstream
It is the installer's responsibility to comply with all national and local plumbing
Phone 904.641.1666
US Toll Free 800.683.2378
Fax 904.642.1012
www.stenner.com
sales@stenner.com
© Stenner Pump Company All Rights Reserved
M128P 411