BEARWARE 303583 Manual Del Usuario página 27

Read this configuration section completely before you start the programming. The
program closes automatically after about 25 seconds.
1. Switch the device on, press and hold the "P" key for about 3 seconds.
2. The configuration starts with the current time setting and the day of the
week.
3. The value to be adjusted starts flashing. You can change the values using
the "+" and "-" keys. You can go to the next menu item using the "P" key.
4. Adjust the minutes (A) and hours (B) of the current time. Then, the day
display (C) at the top starts flashing. This sets the current day of the week
(Monday-Sunday) using the numbers 1 to 7.
1 = Monday, 2 = Tuesday, 3 = Wednesday, etc.
5. By pressing the "P" key again you can program the activation times. This is
indicated by the text "PRG. Weekday (D) ".
6. The programming starts with Monday as the day of the week. This is ap-
parent when the number 1 (E) is displayed. Configure the desired heating
modes for every hour (0 - 23) of this day of week.
7. Each program begins with the hour 0 of 24 "
8. Adjust the heating modes (comfort or ECO) using the "M" key which you
want to start at 0:00-0:59. Using the "+" key, you can toggle through the
hour to be configured, until you reach the hour at which you want to
change the mode.
9. Change the mode and toggle through the hours until the next heat mode
change. You can individually configure every hour from 0-23 hrs.
10. The hours in which the comfort mode is active are shown symbolically on
the display. Hours in which the power saving mode (ECO Mode) is active
remain open.
11. By pressing the "P" key, you can access the configuration of the next day of
the week – The number (E) changes.
12. Repeat the programming as described above for each day of the week.
English
".
27