MELICONI HP STETO DIGITAL Instrucciones De Uso página 16

Headphones (FIG. 2)
Headphone details:
A. On-off button
B. Power/signal LED light from the base
C. Volume control
D. MIC button for listening from the microphone
E. Microphone
F. Audio balance control (left/centre/right)
G. Battery
H. Right earphone
I. Left earphone
Base (FIG. 3)
Details of base unit:
M. Recharging support
N. Tone adjustment LEDs
O. Tone adjustment button
P. Power/incoming audio signal LED light
Q. Main battery charging LED (if battery is inserted in the headphones and the headphones are in the charging slot)
R. Spare battery charging LED (if battery inserted in the smaller slot on the base, behind the main charging slot)
S. Slot for charging the spare battery
T. DC IN power supply input from AC power supply
U. Mono/stereo signal selector
V. Input for optical digital audio cable (Toslink - Optical IN)
Z. Input for analogue audio cable (3.5 mm jack – Audio IN)
• Make sure the base is switched off
• Connect the AC adapter cable to the connector "T" (DC-IN input) on the back of the charging dock.
• Connect the AC adapter to the power outlet.
• The green power supply LED "P" on the base will flash for a few seconds.
• Make sure the headphones are switched off by checking that the "A" switch is in the OFF position.
• Insert one of the two batteries into the headphones, with the correct polarity (FIG. 4)
• Position the headphones in the slot "M" on the base. The main battery charging LED "Q" is lit in green when the battery
is charged, in red if it needs recharged.
• Insert the spare battery into the smaller slot "S". The spare battery charging LED "R", is lit in green if the battery is
charged, in red if it needs charging.
• Before using the headphones for the first time, make sure both batteries are charged and that the charging LEDS
"Q" and "R" are both lit in green; otherwise, wait until they are charged. This may take up to 3 hours (see the section
CHARGING BATTERIES).
CONNECTION TO AUDIO SOURCE (after charging the BATTERIES)
• Before making any connections, ensure that the devices are switched off
• Remove the headphones from the charging dock.
• Identify the optical digital audio output on the TV or on the device you wish to connect.
• Take the TOSLINK optical cable (6) provided, and remove the silicone protections at the ends.
• Use the TOSLINK cable to connect the optical audio output of the TV to the input "V" (OPTICAL IN) on the base.
• If the TV does not have an optical output, use the 3.5 mm stereo audio cable jack (5) and connect the headphone
output of the TV to the input "Z" (AUDIO IN) on the base.
• Switch on the TV or other device.
• Wait for a minute and check that the green LED "P" on the base remains lit, indicating an incoming audio signal.
WARNING: If the LED remains off, or is flashing: if it is connected to the TV with an optical cable, go to the menu of the
TV, activate the optical audio output and select the audio format PCM. For analogue collections (with 3.5 mm jack), turn
up the volume on the TV.
• Remaining close to the base, switch on the headphones by moving the switch "A" to ON and checking that the green
signal reception LED "B" remains lit.
• Put on the headphones and turn the wheel "C" to adjust the volume and obtain correct reproduction of the sounds,
also using, if necessary, the balancing control button "F" on the back of the headphones.
• If the headphones fail to reproduce the sound, or if there is audio interference, please refer to the "TROUBLESHOOTING"
section.
14
Installation