Recharging The Batteries; Technical Specifications - MELICONI HP STETO DIGITAL Instrucciones De Uso

Ocultar thumbs

Contenido

Tabla de contenido

Idiomas disponibles

Use the ON/OFF switch "A" (ON/OFF) on the headphones only to switch them on and off.

If there is no incoming audio signal, the transmitter base will switch off automatically.

To adjust listening volume, use only the wheel "C" on the headphones, and not the volume of the TV

After switching off the headphones, place them back in the charging slot "M" on the base, making sure the LED "Q"

comes on. This will ensure they are already charged the next time you use them.

If the headphones are not being used for a long period of time it is advisable to disconnect the AC power adapter from

the power outlet.

MICROPHONE: The HP Steto Digital headphones have a built-in microphone: it is sufficient to press the "D" (MIC)

button to stop listening to the audio signal from the device connected and to amplify the voices and sounds around

you; the "B" light will come on red when the MIC is active. To resume normal listening of the source connected to the

headphones, press the MIC button again; the "B" light will turn green again.

To recharge the batteries, move the on/off switch "A" of the headphones to OFF and place them back on the base,

making sure the LED "Q" lights up.

The LED "Q" is red while charging; it will turn green when the battery is fully charged. The charge can last for up to 3

hours.

A spare battery is supplied for prolonged use. Just insert it into the slot "S" on the base to charge it. While the spare

battery is charging, the LED "R" is lit red. It will turn green when the battery is fully charged.

With a fully charged battery, the headphones are guaranteed to work for at least 4 hours.

The headphones can be left charging on the base even for several days.

WARNINGS:

When the headphones are not being used, it is advisable to switch them off to avoid running down the batteries and

damaging them.

Make sure the slider "A" is moved to OFF while the batteries are charging.

IMPORTANT:

Always comply with the regulations in force for disposing of the product.

On the base (transmitter), you can select the audio listening tone from 4 different settings,

by pressing the (XX) button on the base in sequence. The selections can be viewed with 3 yellow LEDs "N" "1, 2, 3"as

in the table shown below.

• LEDs off: standard tone

• LED 1 lit: enhancement of high and low tones

• LED 2 lit: enhancement of high tones

• LED 3 lit: enhancement of low tones

Transmission mode:

Frequencies used:

RF output Power

Transmitter power supply

Receiver power supply

Frequency response

Distortion

Signal/noise ratio

Transmission distance

Use