Using Your Fm Wireless Headphone System; Installing/Replacing Batteries; Setting Up The Transmitter - Philips SHC8545 Instrucciones De Manejo

6 ENGLISH
1 Unscrew and remove the left ear cushion of the headphone.
2 Insert the rechargeable batteries into the battery compartment.
3 Make sure the batteries are correctly inserted as indicated by the
4 Put the left ear cushion back into place.
5 Make sure the adapter's rated voltage indicated on the type plate
6 Connect the DC power output connector of the 12 Volt/ 200mA AC/DC
7 Connect the 12 Volt/200mA AC/DC adapter to the mains socket.
8 Place the headphone onto the energizing docking station, and make sure

Using your FM wireless headphone system

• Use only Philips • Use only Philips
12V/200mA AC/DC adapter.
• Use only Philips' shortened sleeve rechargeable batteries NiMH
(R03/AAA, type number: SBC HB550S, partnumber 996500015757).
• Do not use NiCd batteries or alkaline batteries as they may
damage your FM wireless headphone system.

Installing/replacing batteries

Use only Philips' shortened sleeve rechargeable batteries NiMH
(R03/AAA, type number: SBC HB550S, partnumber 996500015757).
engraved polarity symbol in the battery compartment.
Always remove the batteries from the headphone if the system will not be
used for a long period of time.

Setting up the transmitter

corresponds to the mains voltage supply.
adapter to the DC POWER INPUT JACK at the back of the transmitter.
Always remove the adapter from the mains socket if the transmitter will not
be used for a period of time.
Charging the headphone
the charging pins of the transmitter and the charging contact of the
headphone are well aligned.
The CHARGING INDICATOR light will be on automatically indicating
charging is taking place. At the same time, the headphone will power off
automatically (i.e. POWER ON/OFF INDICATOR lights off).
When charging is finished (which takes approximately 16 hours), the green
CHARGING INDICATOR light will also be off automatically.