HAMPTON BAY Minorca Manual Del Propietário página 7

3. Route the wires exiting the top of the fan
motor through the decorative glass housing.
Then route the wires through the canopy
ring and then the canopy. Continue by rout-
ing the wires through the ball/downrod as-
sembly (Figure 9).
UL Listed
Outlet Box
Slide Mounting
Plate Over
Screw Heads
120V Wires
Motor Wires
Downrod/Ball
Canopy
Assembly
Ring
Canopy
Decorative
Glass
Housing
Hanger Pin
Tighten
Screws Motor Collar
4. Loosen, but do not remove, the set
screws on the collar on the top of the
motor housing.
5. Align the holes at the bottom of the
downrod with the holes in the collar
on top of the motor housing (Figure 9).
Carefully insert the bolt through the
holes in the collar and downrod. Be care-
ful not to jam the bolt against the wir-
Mounting Screws
ing inside
(Supplied with
clevis pin through the hole near the end
Outlet Box)
of the hanger pin until it snaps into its
locked position, as noted in the circle inset
Hook
of Figure 9.
Ceiling
Mounting
FAILURE TO PROPERLY INSTALL LOCKING PIN
Plate
AS NOTED IN STEP 5 COULD RESULT IN THE
FAN LOOSENING AND POSSIBLY FALLING.
6. Re-tighten the set screws on the collar on top
Pin in
Locked
of the motor housing.
Position
Installing the Top
Glass Housing
Locking
The glass housing is fragile, use care
Pin
when installing the fan.
1. Remove the two screws and rubber wash-
ers pre-installed on the top of the fan motor
Figure 9
assembly.
2. Carefully place the decorative glass housing
onto the fan motor assembly (Figure 10).
the downrod. Insert the
Screws
And Rubber
Washers
Sockets
3. Align the two screw holes in the decorative
glass housing with the screw holes on the
top of the fan motor assembly and securing
with the screws and washers that were re-
moved in step 1.
4. Install 4 candelabra base bulbs (Max. 15
watts, provided) to the sockets on the fan
motor assembly.
Bulbs
Reversing
Switch
Figure 10
5.