Snap-On MIG185i Manual Del Usuario página 13

knob B and press it for less than 2 seconds. The
A
display screen
figure can be changed and confirmed by pressing the
B
knob for less than 2 seconds.
• AUTO burnback
The adjustment can vary from -9.9 to +9.9. Its purpose
is to adjust the length of the wire coming out of the gas
nozzle after welding. A positive figure corresponds to
greater wire burning.
Default is Auto (preset function). To access this
function, simply highlight it using the knob
press it for less than 2 seconds. The display screen
shows the adjustment bar. The figure can be changed
and confirmed by pressing the knob
2 seconds.
• Soft Start AUTO
Adjustment can vary from 0 to 100%. This is the wire
speed expressed in percentage of the speed set
for welding, before the wire touches the piece to be
welded.
This adjustment is important to always obtain good
starts.
Default is Auto (preset function).
To access this function, simply highlight it using the
B
knob and press it for less than 2 seconds. The
A
display screen
figure can be changed and confirmed by pressing the
B
knob for less than 2 seconds.
• Pre Gas
ADVANCED SETTING cont'd
shows the adjustment bar. The
B
for less than
shows the adjustment bar. The
The adjustment can vary from 0 to 10 seconds.
To access this function, simply highlight it using the
knob
B
display screen
figure can be changed and confirmed by pressing the
B
knob
• Post Gas
The adjustment can vary from 0 to 25 seconds.
To access this function, simply highlight it using the
B and
B
knob
A
display screen
figure can be changed and confirmed by pressing the
knob B
• LCD Contrast
The adjustment may range from 0 to 100%
This function can be used to increase or decrease the
brightness of display screen
To access this function, simply highlight it using the knob
B
and press it for less than 2 seconds. The display
screen A
changed and confirmed by pressing the knob
than 2 seconds.
• Factory OFF
The purpose is to return the welding machine to the
original default settings.
To access the function, simply highlight it using the knob
B . By pressing this for less than 2 seconds, the display
A
screen
the word ALL and briefly pressing the knob
made and the display screen
This indicates the reset has been successful. To return to
the previous display page, simply press the knob
more than 2 seconds.
13
and press it for less than 2 seconds. The
shows the adjustment bar. The
A
for less than 2 seconds.
and press it for less than 2 seconds. The
A shows the adjustment bar. The
for less than 2 seconds.
.
A
shows the adjustment bar. The figure can be
shows the words OFF and ALL. By highlighting
A
B for less
B reset is
shows Factory Done!!
B
for