Quick Start Guide - Snap-On MIG185i Manual Del Usuario

• Stainless Steel 308L
This is typically used to repair many applications in-
cluding stainless steel tanks and containers with a
thickness of .031" to .177".
• Aluminum (AlMg5-5356 and AlSi12-4047)
It is possible to weld on thicknesses of .031" to .276".
Therefore this is widely used in the car body repair, but
also to repair boats and other aluminum structures.
• CuSi3 (Silicon Bronze) MIG Brazing
It is possible to work on galvanized sheets of .024" to
.197".
The main applications is therefore the car body repair,
but it can also be used for repairing other galvanized
structures within the maximum thickness.
1- TURN ON THE WELDER USING THE ON/OFF
SWITCH.
date of the software, and the release number of the
synergic curves.
A
The display screen
used, the start mode
2T, 4T ,3L the welding current, the speed of the welding
wire in inches/min, the welding voltage, the thickness of
metal to weld in inches and the welding process
ASSEMBLING THE UNIT cont'd

QUICK START GUIDE

When the machine
switched on, for a few
moments the display screen
A
displays: the
number of the machine, the
version and development
will then show the synergic curve
short
MIG
is
To increase or decrease the welding parameters, simply
adjust by means of knob
together in a synergic way.
model
2- SET THE WIRE SIZE AND WELDING GAS
To access these functions, we must start from the main
display page and press the knob
To enter the function, simply select it by means of the knob
B
and press it for less than 2 seconds. To return to the main
display page, press the knob
9
or pulse
MIG
B
. The values all change
B
for at least 2 seconds.
B
for at least 2 seconds.