Braun SmartControl 5729 Manual Del Usuario página 7

Description
1 Foil protection cap
2 Shaver foil
3 Cutter block
4 Long hair trimmer
5 Charging light
6 On/off switch
7 Special cord set
Charging
The best environmental temperature for charging is between 60 °F to 95 °F/
15 °C to 35 °C.
• Using the special cord set, connect the shaver to an electrical outlet with
the motor switched off.
• When charging for the first time, leave the shaver to charge continuously
for 4 hours. The charging light (5) shows that the appliance is being
charged. When the battery is fully charged, the charging light turns off.
Intermittent blinking after a while indicates that the battery maintains its full
capacity. This can also happen short term when charging after the battery
was completely discharged.
• A full charge provides up to 30 minutes of cordless shaving time
depending on your beard growth.
• Once the shaver is completely charged, discharge the shaver through
normal use. Then recharge to full capacity. Subsequent charges will take
about 1 hour.
• Maximum battery capacity will only be reached after several charging/
discharging cycles.
• If the rechargeable batteries are discharged, you may also shave by
connecting the shaver to an electrical outlet via the special cord set.
Shaving
Remove the foil protection cap (1). Activate the on/off switch (6). The floating
foil frame automatically adapts to your skin surface for a close, smooth
shave.
For pre-shaving after a few days of not having shaved, use the long hair
trimmer (4) to pre-cut long hairs. For a close, smooth shave, finish with the foil.
8