Sauder 421192 Manual Del Usuario página 21

Step 16
Carefully turn your unit onto its front edges. Unfold the BACK (M)
å
and lay it over your unit.
Make equal margins along the two side edges of the BACK (M).
å
The bottom edge of the BACK (M) and bottom surface of the
BOTTOM (I) should be even. Push on opposite corners of your
unit if needed to make it "square".
Fasten the BACK (M) to your unit using the NAILS (1N).
å
NOTE: Be sure to tap NAILS into the holes that line up over
å
the UPRIGHTS (C).
NOTE: Perforations have been provided for access through the
å
BACK. Carefully cut out the holes needed.
www.sauder.com/service
The top edge of the BACK should be down
slightly from the top edge of the TOP.
M
I
421192
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
NAIL
(62 used in this step)
These holes must line up
over the UPRIGHTS (C).
1N
Page 21