Battery Installation Colocación De Las Pilas - Fisher-Price BFB08 Manual Del Usuario

Tabla de contenido

Publicidad

Battery Installation Colocación de las pilas
3
Toy Bar
• Locate the battery compartment door on
the toy bar.
• Loosen the screws in the battery
compartment door and remove it.
• Insert three AA (LR6) alkaline batteries.
• Replace the battery compartment door
and tighten the screws.
• If the toy bar begins to operate erratically,
you may need to reset the electronics.
Slide the power/volume switch off and
back on.
• When sounds or lights become faint or
stop, it's time for an adult to change
the batteries.
Barra de juguetes
• Localizar la tapa del compartimento de
pilas en la barra de juguetes.
• Aflojar los tornillos de la tapa del
compartimento de pilas y retirar la tapa.
• Introducir 3 pilas alcalinas AA (LR6) x 1,5V.
• Cerrar la tapa del compartimento de pilas
y apretar los tornillos.
• Si la barra de juguetes no funciona
correctamente, restablecer el circuito
electrónico. Poner el interruptor de
encendido/volumen en apagado
y nuevamente en encendido.
• Cuando los sonidos o luces pierdan
intensidad o dejen de funcionar, es hora
de sustituir las pilas.
1,5V x 3
AA (LR6)
• Protect the environment by not disposing
of this product with household waste
(2002/96/EC). Check your local authority
for recycling advice and facilities.
• Proteger el medio ambiente no desechando
este producto en la basura del hogar
(2002/96/EC). Consultar con la agencia local
pertinente en cuanto a información y centros
+
de reciclaje.
ICES-003
This Class B digital apparatus complies with
Canadian ICES-003. Operation is subject to
the following two conditions: (1) this device
may not cause harmful interference and
(2) this device must accept any interference
received, including interference that may
cause undesired operation.
NMB-003
Cet appareil numérique de la classe B est
conforme à la norme NMB-003 du Canada.
L'utilisation de ce dispositif est autorisée
seulement aux conditions suivantes:
(1) il ne doit pas produire de brouillage et
(2) l'utilisateur du dispositif doit être prêt
à accepter tout brouillage radioélectrique
reçu, même si ce brouillage est susceptible
de compromettre le fonctionnement
du dispositif.
10

Publicidad

Tabla de contenido
loading

Tabla de contenido