Accessory Storage Holder; Accessory Storage; Cord Wrap - RIDGID WD14500 Manual Del Usuario

SP6735-3 RIDGID ES

Accessory Storage Holder

Installing Accessory Storage
Holder
1. Position rods of accessory storage
holder directly over accessory rod
receptacles in dust drum.
2. Slide accessory storage holder into
accessory rod receptacles until fully
seated with holder clips locked.

Accessory Storage

Holder Clips
Accessory Storage
Your accessory storage holder has been
designed to hold all the accessories
included with your vac. The accessories
and hose should be stored as shown.
NOTE: Insert female end of extension
wand into the holder sleeve as shown.
Female End
of Extension
Wand
6/13/12 2:35 PM
Accessory
Storage
Holder
Accessory
Holder
Receptacles
Accessory
Storage
Holder
Page 8
Removing Accessory Storage
Holder
Push in both accessory storage holder
clips and then pull straight up on rods of
accessory storage holder.
Accessory Storage
Holder Clips

Cord Wrap

When vacuuming is complete, unplug the
cord and wrap it around the power
assembly as shown. The cord should wrap
under the pull handle (above the inlet) and
around and under the cord wrap of the
motor cover.
Push/Pull Handle
8
Accessory
Storage
Holder
Accessory
Holder
Receptacles
Cord Wrap
Power
Cord