Factory Settings - Hydrofarm autopilot APCECOD Instrucciones

CO FUNCTION - Press button to select the photocell function.
2
CO MODE - Press button to select the CO
2
CALIBRATE CO PPM - Press button to re-calibrate the CO
2
SPECIAL BUTTONS
CO Min / Max - Press this button repeatedly to recall the stored high and low recorded levels for CO
2
Press and hold the ENTER/RESET button while the recorded value is displayed to RESET the Min/Max
values.
ERROR LEDS
The APCECOD is smart enough to monitor the CO
the device connected to the APCECOD. Here is how it works.
As the unit functions normally, the CO
are detected by the controller.
If the controller does not detect a slight change in the CO
de-activate the CO output and the green error LED will be flashing to indicate the CO
2
have a problem.
This safety feature is extremely important and useful to eliminate "runaway" conditions which could
result in crop damage or other more serious problems.
If the error LEDs are blinking, the user should check the CO
function.
NOTE: To RESET an error, press the ENTER/RESET button.

FACTORY SETTINGS

The APCECOD comes pre-programmed with factory settings. These settings may be adjusted by the
user. For best results verify any changes after adjusting settings. The controller can be easily RESET to
factory settings. (See below)
CO PPM setting
2
CO deadband
2
Calibrate CO PPM
2
CO Function
2
CO Mode
2
Fuzzy Logic
RESET Factory Settings - Press and hold the ENTER/RESET and down buttons for 3 seconds. The display
will read f.Set. Press the ENTER/RESET button again to restore the factory default settings. The unit will
go through a self-test and when the factory RESET is complete, the unit will say donE.
INSTRUCTIONS
mode, to increase or decrease CO
2
conditions and to alert the user to a problem with
2
level will be slowly but steadily changing. These small changes
2
1250 PPM
50 PPM
380 PPM
Daytime
Increase
(Off) Generator mode
2
sensor.
2
level within a 1-hour period, the unit will
2
device and remote sensor for proper
2
levels.
device may
2
.
2
3