Tips & Troubleshooting - Gallagher MBS100 Instrucciones

3E4723 Gallagher MBS100 MBS200 MBS400 MBS800 Multi-Power User Manual
TIPS & TROUBLESHOOTING
• Turn off energizer before handling fence or battery connections.
• Install solar energizers on a post above the ground.
Symptom Problem
Energizer has The internal
started to temperature of the
run slowly energizer is too high
Low battery capacity
Energizer Battery has less
does not than 10% capacity
operate remaining
Energizer is Off
Faulty energizer
Electric fence Faulty energizer
voltage is
below 3000V
or your stock
are escaping
Inadequate earthing
Loose connections
Solution
Mount the energizer in a cool area, out of
direct sunlight and with adequate ventilation.
Check battery voltage using the battery check
mode. Replace with fully charged battery or
ensure solar panel is getting enough sun to
allow batteries to charge.
Replace with fully charged battery or ensure
solar panel is getting enough sun to allow
batteries to charge.
Check power source is connected. Ensure
mode selector switch is ON.
Have energizer repaired.
Disconnect energizer from fence and earth.
Measure across the fence and earth terminals
using a Gallagher fence volt meter. If the
voltage is less than 5000v, have energizer
repaired.
Improve the earth system by adding more
galvanised earth stakes to the earth system
until the earth voltage is 200V or below.
Check the electrical connections are secure e.g.
from the fence to the red terminal, from the
earth system to the green terminal, at gates
etc.
17