Fulbat FULLOAD 1500 Manual De Instrucciones página 6

 The Red LED is ON and Yellow LED is ON, (the initial voltage is at very low level).
Enhanced Battery Rejuvenation
Two alternative- rejuvenation stages work in turn to the stratified electrolyte liquid and lead sulphated crystal, which is not
only dissolve the lead sulphated crystal but also bring the electrolyte fluid to a well-distributed state, it consists of two
alternative stage with high voltage equalizing stage (16V or enhanced 20V) and high peak pulse reconditioning stage.
If the battery is detected under an extreme flat or heavy sulphated stage, further, the program will automatically detect
whether the battery is connected into the vehicle electronic system, if detected the battery has been connected into the
vehicle electronics system, the battery charger will engage a safe rejuvenation method; which is to run high voltage
equalizing stage (16V) and high peak pulse reconditioning stage alternatively; If detected the battery is not connected into
the vehicle electronics system or battery moved from the vehicle, the program will engage an enhanced equalizing voltage
(20V) and peak pulse conditioning stage for the extreme flat batteries.
If the program detects the battery is slightly sulphated, it will run high voltage equalizing stage (16V) and high peak pulse
reconditioning stage alternatively.
 The Blue LED is flashing indicates the Rejuvenation stage.
If the program detects the battery can be normally accepted charging current, it will directly go into Soft start stage; if the
battery still cannot accept the charging current after 24 hours of rejuvenation, it expresses that the Battery Rejuvenation
fails and that the battery is not healthy.
 The Red LED will be ON to indicate the battery rejuvenation failure.
Smart Charging Mode
There are following stages:
o
Soft start Charging Mode (C.C. Mode)

Blue Charging LED is flashing.

Gently ramps up the battery voltage to 11V
o
Bulk Charging Mode (C.C. Mode)

Blue Charging LED is ON.

The battery can be charged about 80%.

The charger delivers an almost constant current 1500mA until the battery voltage reaches the set
value.
o
Absorption Mode (C.V Mode)

Blue Charging LED is ON.

The battery can charge up to almost 100%.

The charging current tapers and the charging voltage are kept constant at the set value.
o
Analysis Mode (Battery retention test Mode)

The charging is interrupted for a short period for battery voltage measured

If the battery voltage falls too quickly, the battery is probably faulty.

The Yellow Charging LED is ON (if above situation occurred)
o
Float Mode (Safe voltage level of 13.6V)

Full Green LED is ON.

The Float Mode allows the charger to effectively be left connected to your batteries; it works at a safe
level of 13.6V, and ready for use.
o
Maintenance mode (Special pulse for long term maintenance)

Full Charge Green LED is ON.

The program engages a special charging waveform and monitors the battery voltage variety, if the
battery voltage sinks, the special pulses will keep the battery in optimal state, if the battery voltage
drops even lower, the battery charger will switch into Bulk charging stage. The maintenance mode
allows the charger can be connected to the battery over the course of a season; if possible; check the
electrolyte liquid level in the battery.

If the Battery is out of the vehicle.
o
Switch OFF and Remove the AC Power Socket from the outlet.
o
Remove the Black lead and then the Red lead.
STEP 4 - Disconnecting the Battery charger from Battery