Safety Symbols; Eye Protection - Craftsman 5166 Manual Del Operador

min
The purpose of safety symbols is to attract you attention to possible dangers.
The safety symbols and the explanations with them deserve your careful
attention and understanding. The symbol warnings do not, by themselves,
eliminate any danger. The instructions and warnings they give are no
substitutes for proper accident prevention measures.
ѥ
WARNING: Be sure to read and understand all safety instructions in this
manual, including all safety alert symbols such as "DANGER," "WARNING,"
and "CAUTION" before using this tool. Failure to follow all instructions listed in
this manual may result in electric shock, fire, and/or serious personal injury.
SYMBOL SIGNAL MEANING
SAFETY ALERT SYMBOL: Indicates DANGER, WARNING, or CAUTION; may
.../min
be used in conjunction with other symbols or pictographs.
ѥ
DANGER: Indicates a hazardous situation which, if not avoided, will result
in death or serious injury.
ѥ
WARNING: Indicates a hazardous situation which, if not avoided, could
result in death or serious injury.
ѥ
CAUTION: Indicates a hazardous situation which, if not avoided, could
result in minor or moderate injury.
Damage prevention and Information Messages
These inform the user of important information and/or instructions that could
lead to equipment or other property damage if they are not followed. Each
message is preceded by the word "NOTICE", as in the example below.
NOTICE: Equipment and/or property damage may result if these instructions
are not followed.
ѥ
WARNING: To ensure safety and reliability, all repairs should be performed
by a qualified service technician.
ѥ
WARNING: Risk of fire and burns. Do not recharge, disassemble, heat
above 212 OF (100 OC), or incinerate. Keep battery out of reach of children and
in the original package until ready to use. Dispose of used batteries promptly
according to local recycling or waste regulations.

SAFETY SYMBOLS

Read The Operator's Manu
WARNING: The operation of any power tools can result in foreign
objects being thrown into your eyes, which can result in severe eye
damage. Before beginning power tool operation, always wear safety
goggles or safety glasses with side shield and a full face shield when
needed. We recommend a Wide Vision Safety Mask for use over
eyeglasses or standard safety glasses with side shields. Always use
eye protection which is marked to comply with ANSI Z87.1.
Minutes
Alternating Current
Direct Current
No Load Speed
Class II Construction
Per Minute
Wet Conditions Alert

Eye Protection

Safety Alert
3