e-conolight E-FFC05 Serie Instrucciones De Instalación

INSTALLATION INSTRUCTIONS
E-FFC05 and E-FFC08 Series
CAUTIONS
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety
precautions should always be followed including the
following:
READ AND FOLLOW ALL
SAFETY INSTRUCTIONS
1. DANGER- Risk of shock- Disconnect power before
installation.
DANGER – Risque de choc – Couper l'alimentation
avant l'installation.
2. This Product Must Be Installed In Accordance With The
Applicable Installation Code By A Person Familiar With
The Construction And Operation Of The Product And
The Hazards Involved.
Ce Produit Doit Être Installé Selon Le Code D'installation
Pertinent, Par Une Personne Qui Connaît Bien Le
Produit Et Son Fonctionnement Ainsi Que Les Risques
Inhérents.
3. Suitable for Wet Locations.
Adspte pour les Endroits Mouiles.
4. Suitable for mounting within 1.2 m (4 ft) of the ground.
Peut être installé à moins de 1,2 m (4 pi) du sol.
5. Keep combustible and other materials that can burn away
from lamp/lens minimum 3 inches.
SAVE THESE INSTRUCTIONS
FOR FUTURE REFERENCE
www.e-conolight.com |
Document: LPN00670X0002A0_A
Created By:
TMT
U-BRACKET MOUNTING
(Requires use of E-ACU-FFC-SML Accessory)
1. Connect cord leads inside wiring housing to fixture leads using
supplied wire nuts. Connect cord green wire to fixture ground wire
(green). Connect cord white wire to fixture common wire (white).
Connect cord black wire to fixture voltage wire (black). See
Figure 1.
2. Attach wiring housing to inner (4) threaded holes on fixture
housing using supplied ¼"-20 x ½" long Allen bolts and Allen
wrench. Tighten bolts to 72 in-lbs (8.1 N•m).
3. Remove black plugs from (4) outer threaded holes. Attach upper
yoke bracket to outer threaded holes using supplied ¼"-20 x ³⁄
long Allen bolts and Allen wrench. Tighten bolts to
72 in-lbs (8.1 N•m).
4. Mount fixture in intended location using (2) customer supplied
¼" (6 mm) fasteners and washers appropriate for the mounting
surface.
NOTE: Outer holes in lower U-bracket can be used as a template
for locating holes on mounting surface.
5. Aim fixture by loosening bolts on sides of U-bracket and rotating
fixture to desired tilt angle. Once fixture is properly aimed, re-
tighten bolts to 72 in-lbs (8.1 N•m)
FIGURE 1
Outer Threaded
Holes
½"
(4) Long
Allen Bolts
Upper
U-Bracket
(1) Bolt on
Each Side of
U-Bracket
888.243.9445 | FAX: 262.504.5409
Date 10-30-2019
ECO#
011204
"
8
Inner Threaded
Holes
Outer
Threaded
Holes
Gasket
Wiring
Housing
³⁄ "
(4) Long
8
Allen Bolts
Lower
U-Bracket