English; Steam Function - Braun Steam & style pro Manual Del Usuario

English

Our products are developed to meet the highest
standards of quality, functionality and design. We
hope you thoroughly enjoy the new Braun appli-
ance. Carefully read the use instructions before
use.
Braun steam & style pro with integrated steam
function is suitable for pre-drying wet hair and
styling towel dry or damp hair as well as for styling
and refreshing dry hair.
Important
• Plug your appliance into an alternating current
outlet only and make sure that your household
voltage corresponds to the voltage marked on
your appliance.
• This appliance must never be used near
water (e.g. a filled wash basin, bathtub
or shower).
Do not allow the appliance to become
wet.
• Never fill water directly in the heating tube.
• For additional protection, it is advisable to
install a residual current device (RCD) with a
rated residual operating current not exceeding
30mA in the electrical circuit of your bath-
room. Ask your installer for advice.
• This appliance is not intended for use by
children or persons with reduced physical
or mental capabilities, unless they are given
supervision by a person responsible for their
safety. In general, we recommend that you
keep the appliance out of reach of children.
• Do not wrap the mains cord around the appli-
ance. Regularly check the mains cord for wear
or damage. The mains cord of the appliance
may only be replaced by an authorised Braun
Service Centre. Unqualified repair work can
lead to extreme hazards for the user.
• Always unplug after use. If plugged in, the
appliance will continue to heat even on the
« »-setting. Even switched off, the appli-
ance presents a hazard when near water.
• The maximum environmental temperature for
operating the appliance is 30 °C.
Description
a Water reservoir
b Release button for attachments
c Switch ring (works with warm or cold air,
depending on the setting):
= Heating system for the steam function
is activated and working after approx.
2 minutes.
8
«1» = Warm air setting to style a medium and
small amount of hair and to create
volume at the roots.
«2» = Drying/styling setting to style a big
amount of hair.
«3» = Power setting for fast pre-drying wet hair,
especially with the volumizer attachment
(only with steam & style pro).
= Cool shot setting for styles to
last longer (is activated on all
settings («1», «2», «3») when
pulling and holding the switch
1 2 3
ring).
d Removable filter
e Power control light
f Hanging hook
g Big brush attachment
h Small brush attachment
i Volumizer attachment
(only with steam & style pro)
Before use
Each time before filling with water unplug the
appliance.
1 Pull the water reservoir off the appliance
(illustr. 1).
2 Turn to open the water reservoir (illustr. 2).
3 Fill the water reservoir with tap water to the
top of the black rubber ring and close tight the
water reservoir (illustr. 3).
4 Re-insert the water reservoir until it snaps into
place (illustr. 4).
5 Plug into an electrical outlet. The power con-
trol light lights up. Let the appliance heat up
on the « »-setting. Ready for steaming after
2 minutes (illustr. 5).
After use
Always empty the water reservoir.
Styling
• Big brush attachment for big curls
• Small brush attachment for medium and small
curls
• Volumizer attachment
(only with steam & style pro)

Steam function

The steam function can be used with all attach-
ments. To add steam to a streak of hair press the
top of the water reservoir (you will hear a click).