Price Pfister Marielle 34 Serie Instrucciones De Instalación página 4

11
11 SOAP DISPENSER INSTALLATION
Insert threaded Shank (11A) of soap dispenser body through Foam Gasket (11B)
and sink hole. Tighten Nut (11C) and thread on Bottle (11D) to Shank (11A).
12
12 SOAP DISPENSER HEAD INSTALLATION
Pour in liquid soap (not included) into the Shank Orifice (12A). Insert Pump
Mechanism (12B) into soap dispenser body. Install Dispenser Head (12C) by
pushing firmly onto dispenser mechanism.
11A
11B
11C
11D
12C
12B
12A
ENGLISH
13
13D
13 WATER SUPPLY LINES
Gently separate hot and cold Supply Tubes (13A), approximately three inches
apart. Connect water Supply Lines (13C) to Faucet Inlets (13B). Hot water
supply line goes to hot inlet fitting indicated by red tag (13D). (Supply lines not
included). Follow manufacturer's instructions when installing supply lines. Do
not twist Supply Tubes (13A)!
14
14 UNIT START UP
Turn on hot and cold water supplies, and check for leaks above and below
the sink.
15
15A
15 FLUSHING
To prevent damage to the internal parts of your faucet from debris that may
have collected in the water lines, it is important to flush your faucet. Remove
Aerator (15A) and turn the Handle (15B) to the full "ON" position. Run water
for one minute. Repeat in hot and cold positions. After flushing, turn off handle
and replace Aerator (15A).
4
13A
13B
13C
13C
HOT
15B
COLD