Floor Fixing - SportTech FPR300 Manual De Instrucciones

5
At the bottom of the stand frame there are flat connectors with 6 holes that are used for fastening to
the floor. Floor anchoring is necessary for secure, stable fastening of the device. Use the fastening/fixing
material supplied. Make sure that the floor is level beforehand and is suitable for permanent installation.
IMPORTANT: Please also note the relevant safety instructions at the beginning of this manual.
1. Before drilling, make sure that the device has sufficient space at the installation site, is freely acces-
sible and that no access is blocked.
2. Set up the device as desired and mark the drill holes through the holes according to the holes on
the stand frame. Put the device to one side before drilling!
3. Drill holes in the ground with a 10 mm bit and drive in the ground anchors. Make sure that the
anchor sleeves disappear into the ground at ground level and only the threaded pins stick out.
4. Remove the nuts, spring washers and washers from the anchors, place the unit in the position above
the floor anchors, and screw the retaining plates to the floor by re-installing the washers, spring
washers and nuts.
5. Tighten the nuts firmly!

FLOOR FIXING

38