Publicidad
THE RENEWABLE ENERGY KIT
WORLD CLASS BY DESIGN
The Renewable Energy Kit has been designed to support the teaching
INSTRUCTIONS
of many stages and levels of the British National Curriculum, the
most direct links can be made with the Geography and Science
programmes of study from keystage 1 – 4.
The Renewable Energy Kit is tested to EN 71 and EN 50 088
safety standards for electronic toys.
The kit comprises of the following components:
•
Wind Turbine
•
Water Turbine - 1 Inlet / 1 outlet pipe
•
Solar Panel
•
Universal Base
•
Universal Mast Section
•
Output Dials -
1. PowerMeter
2. Light Display (LED)
3. Alarm /Buzzer
4. Motion Display (gears)
1) Demonstrations of the Renewable Energy Kit should be
supervised at all times by an adult.
2) Stand clear of, and do not interfere with, the moving Wind
Turbine blades.
3) The orange ON/OFF Switch on the Universal Base will
stay DOWN when in the ON position.
4) It is important to ensure that when assembling or
interchanging any elements or output dials of the Removable
Energy Kit that the ON/OFF switch is in the OFF position.
5) Make sure you are near enough to electricity or water
supplies for demonstrating indoors.
6) Plug the Universal Mast into the base (Note that the water
device plugs directly into the base without the pole.)
ASSEMBLY & INSTRUCTIONS
Water Turbine Pipes
7) Add the Solar Panel Display or Wind Turbine to the top of the
8) When using the Solar Panel Display, weak winter sunshine is
9) When using the Wind Turbine indoors, a desk fan or hairdryer can be
10) When using the Water Turbine, connect tubing to each of the
Wind Turbine
Universal Mast
Universal Base
Universal Mast and you're ready to start.
usually sufficient to generate an output. When using the solar panel
with artificial light THE LIGHT SOURCE MUST BE DIRECTED
TO THE CENTRE OF THE SOLAR PANEL.
used to simulate the wind.
nozzles on the back of the device. When looking at the back it is
essential to ensure the water input is connected to the right hand
nozzle. Make sure the end of the water outlet is somewhere sensible!
The tubing will easily fit onto most taps but an adaptor may be
required for conventional taps (not supplied.)
Interchangeable Dials
Power Meter
Light Display
Alarm/Buzzer
Motion Display
(Gears)
Publicidad
