Dash Disassembly - Metra 95-7353CH Guia De Instalacion

1. Unclip and remove the factory
radio trim panel including the a/c
vents. (Figure A)
Note: Remove the (8) retaining
clips to be reused in Kit Assembly.
2. Remove (4) Phillips screws
securing the radio in the dash.
3. Remove (2) Phillips screws
securing the start/stop switch if
equipped. (Figure B)
(Figure A)
95-7353CH

Dash Disassembly

4. Remove (4) Phillips screws securing
the storage pocket (Figure B)
5. Remove the (8) Phillips screws
securing the a/c vents then unclip
and remove them from the radio
trim panel. (Figure B)
6. Unclip and remove the hazard
switch. (Figure B)
7. Remove (3) Phillips screws
securing the passenger air bag
indicator. (Figure B)
Continue to kit preparation
Step 3
(Figure B)
2
Step 5
Step 6
Step 4
Step 7