1. Unsnap and remove the top half of the
shift knob. (Figure A)
2. Remove (1) T-30 Torx screw securing the
knob and then remove the knob. (Figure B)
3. Unsnap and remove the panel
surrounding the shift knob. (Figure C)
2
DASH DISASSEMBLY
(Figure A)
(Figure B)
(Figure C)
4. Using the panel removal tool, carefully
unclip, unplug and remove the radio/
climate control panel. (Figure D)
Note: The harness removed from
this panel will connect to the climate
extension cable.
5. Remove (2) Phillips screws securing the
pocket below the climate control panel,
and then unclip and remove the pocket.
(Figure E)
6. Remove the (4) Phillips screws securing
the radio chassis, and then unplug and
remove the chassis from the dash cavity.
Note: The white round cable connected
to the radio chassis will connect into
the Axxess interface to drive the factory
display screen.
Continue to Kit Assembly
(Figure D)
(Figure E)
|
386-257-1187
MetraOnline.com