Parts List - Foundations 100-SSV-SM Instrucciónes Para La Instalacción

ADULT INSTALLATION REQUIRED.
TOOLS REQUIRED:
Level (A)
Measuring tape (B)
Power drill (C)
•
READ ALL INSTRUCTIONS BEFORE ASSEMBLY OF DIAPER CHANGING STATION
•
Unpack carton and identify all parts.
•
This changer has six (6) recess mounting holes.
•
The diaper changing station is no stronger than the anchors or walls to which they are attached and, therefore,
MUST be firmly secured in order to support the weight they are intended to support. It is recommended that this unit be
installed in a recessed fashion. If surface mounting, contact an architect, building contractor, or Professional Engineer
for proper installation and hardware. Contact an architect or building contractor if any questions.
•
Child should never be left unattended.
•
Avoid serious injury from falling or sliding out. Always use restraint system.
•
Adding excessive weight such as parcels, packages, or accessories to the unit or to the bag hooks that exceed the total
weight limit of 50 pounds (22.7 kg) may cause the unit to be unstable or may cause a hazardous unstable c ondition to
exist.
Parts Description
Door / Wall Plate
33-3/8
(848 mm)
20-3/4"
(527 mm)
(Door)
OPERATION:
Rotate base downward. Place infant on top of the changing surface. Use restraint system as described below. After child has
been changed, remove restraint system and rotate base back up against the wall.
USE OF RESTRAINT SYSTEM:
Place child so restraint strap is located at abdomen. Rotate top of buckle upward and
insert strap in buckle. Pull strap through buckle until snug against infant. Rotate top of
buckle downward to lock the strap into place. Slide red locking tab over top of buckle
(Fig. a). Reverse steps to loosen strap.
MAINTENANCE AND CLEANING:
Check all hardware and components monthly or as required to ensure hardware is tight and there
are no missing or damaged components. Take unit out of service if any component is missing or
damaged and contact customer service to order replacement parts. Do not substitute parts.
For replacement parts, contact customer service at
by using a damp cloth with mild soap or mild multi-purpose cleaner. Do not use any strong
chemical cleaners or cleaning agents that may be hazardous to children.
ASSEMBLY INSTRUCTIONS
A
WARNING

PARTS LIST

Door / wall plate to be
mounted on outside of
restroom door.
30-3/8"
(771 mm)
(R)
33-7/8"
(860 mm)
(SM)
1
IMPORTANT: Due to widely varied wall material,
anchoring to be determined by architect or engineer.
A.D.A. Compliance:
Compliant when properly installed.
306.3 Knee clearance.
307.2 Maximum protruding objects.
308.2 Forward reach.
308.3 Side reach.
309.4 Operation.
902.3 Work Surface.
Top Of
Buckle
B C
Quantity
1
Locking
Tab
Fig. a