Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Resetting the motor to factory default
Follow the procedure described in either
Case #1:
Both motor buttons, the red and the blue ones, do not "click" when pressed.
Make sure you release the mechanism. To do this, remove the track
the motor and remove the
wall control
1.
On the
button
until the motor stops on its own. If the
button you pressed does not start the motor, try
the opposite
direction
direction button
you selected in this step.
2.
Press the
stop button
3.
Test the
red
and
blue buttons
point one of them should be able to make a
"click" sound. That button is now unlocked.
4.
Press and hold the button that is unlocked on
the motor until you complete step 5. On the wall
control, press the
button
to that selected in step 1 and allow the motor to
operate until it stops on its own.
5.
On the wall control, press the
then release the button that was pressed on the
motor.
6.
red
blue buttons
Test the
and
time, both buttons should be able to emit a
"click" sound when pressed. Both buttons are
now unlocked, allowing for new limits to be set.
The motor is now set to its factory default settings. Place the
procedure to adjust the limits
Case #1
GEAR
to release the mechanism
, press either
direction
button. Remember which
wall control
on the
.
again. At this
in the
opposite direction
stop button
and
again. At this
(p.
3).
© 2018. Vertilux, Ltd. All Rights Reserved. Last revised: October 2018.
Case #2
or
depending on your situation:
COVER
(p. 2, fig.
2).
UNLOCKED
BUTTON
STOP
BUTTON
GEAR
back. You can now follow the
located on the side of
DIRECTION
BUTTON
STOP
BUTTON
RED OR BLUE
BUTTON IS
UNLOCKED
OPPOSITE DIRECTION
BUTTON
RELEASE
RED OR BLUE
BUTTON
RED AND BLUE
BUTTONS ARE
UNLOCKED
vertilux.com
5
Publicidad
Tabla de contenido
