Publicidad
• Connect the Black wire to chassis ground, and also to the Black wire of the AX-CAM6V.
• Connect the Red wire labeled "Camera Power 6V" to the Blue/Red wire of the AX-CAM6V.
• If retaining steering wheel controls, connect the unlabeled Red wire to accessory power.
• Connect the Green/Purple wire to the reverse wire of the aftermarket radio,
and also to the Blue/White wire of the AX-CAM6V.
To the aftermarket radio:
• Connect the Yellow RCA jack to the backup camera input.
• If retaining the factory AUX-IN jack, connect the Red & White RCA jacks to the AUX input.
The following (2) wires are for aftermarket multimedia/navigation radios that require these wires:
• Connect the Light Green wire to the parking brake wire.
• Connect the Blue/Pink wire to the speed sense wire.
With the key in the off position:
• After the radio has been tested and working, connect the AX-SUB28SWC-6V harness to the vehicle,
and then into the ASWC-1.
• Refer to the ASWC-1 instructions for radio connections and programming.
Note: Disregard the harness that comes with the ASWC-1.
Connections to be made
Installing the AX-SUB28SWC-6V
K
®
NOWLEDGE IS
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
Integrate • AxxessInterfaces.com
© COPYRIGHT 2020 METRA ELECTRONICS CORPORATION
AX-SUB28SWC-6V
INSTALLATION INSTRUCTIONS
P
OWER
Metra recommends MECP
certified technicians
REV. 2/24/20
Publicidad
