CARE AND CLEANING
The surface of the cabinet can be damaged if not properly maintained. Many common house-
hold aerosol sprays, cleaning agents, solvents and polishes will cause permanent damage to the
fine surface.
1. Unplug the power cord before cleaning the television.
2. Clean the screen and cabinet with a soft dry cloth.
Note: Never spray liquids on the screen because they can run down and drip onto the chassis.
This may cause component failure not covered under Warranty.
TROUBLESHOOTING
Before calling for assistance, please look for the condition that most closely resembles your problem
in the following charts, then follow the instructions for that condition. Visit our Web site at
www.sanyoctv.com
TV Turns off by itself
Check antenna
connection.
No Picture or Poor Picture
Change Channels.
Poor color or no color
Change Channels.
or call toll free 1-800-877-5032.
Was the connector loose or disconnected?
Yes. Problem could be auto shutdown due to loss of signal. (See page 4.)
No.
Press the POWER key.
Did the TV come on?
Yes. Sleep Timer may have been set.
No.
Is picture ok?
Yes. Problem is with signal (station, cable, or satellite reception).
No.
Turn off household/shop appliances such as, vacuum, blender, drill, etc.
Did picture improve?
Yes. Problem was interference from an appliance.
No.
Is color better?
Yes. Problem is with program or signal (station, cable, or satellite reception).
No.
Adjust antenna direction/alignment.
Did color improve?
Yes. Antenna was not adjusted properly for the channel you're watching.
No.
Unplug the TV for a few seconds. Reconnect and press POWER.
Adjust antenna direction/alignment. / Press the RESET key twice
(personalized settings will be reset to factory defaults).
Press the RESET key twice (personalized settings will be reset to
factory defaults).
(Continued on page 20.)
19