Pip Operation - Sanyo DS270820 Manual Del Propietário

QuickTips
Make sure all cable
connectors are fully
seated on jacks.
Always match cables
according to the
colors; for right
RED
audio, for left
WHITE
audio and for
YELLOW
video.
A/V1 and A/V2 jacks
have identical
functions. Any
compatible video
equipment can be
connected to either
set of jacks.
A solid Blue screen
with the word Video1
or Video2 displayed
means that the Video
mode is selected, but
no signal is being
detected at the
Video jack. Check
connection, and
turn on external
equipment.
Make sure you select
TV channel to match
your VCR output
(Ch. 3 or 4).
You may be able to
use the remote
control to operate
your VCR, Cable
Box, and DVD.
(See pages 7 ~ 8.)
Need help?
Visit our Web site at
www.sanyoctv.com
or Call 1-800-877-5032
12
CONNNECTING EXTERNAL EQUIPMENT
FOR PIP OPERATION
The PIP feature requires two signals to work: You must connect signals to the 75 ohm
terminal and to one set of the A/V jacks; or you must connect signals to both sets of A/V jacks.
CONNECTING A CABLE BOX AND VCR OR TO THE TV
Switch off TV and external equipment before connecting cables. (Cables and splitter
are not supplied.)
1. Connect signal (cable) to splitter
2. Connect cable from splitter
3. Connect cable from splitter
4. Connect cable from cable box out
5. Connect VCR's Audio Out (R/L) and Video Out to the TV
Audio Input (R/L) and Video Input
For Mono VCR (Single Audio Jack) connect VCR Audio Out to TV Audio (L) Input.
Note: Use either A/V1 or A/V2 Input jacks.
Optional
6. Connect DVD, VCR, DSS, or other equipment's S-Video Out to the TV S-Video In
jack . Note: Using the S-Video In jack overrides the Video1 Input jack
7. Press POWER
to turn on the TV
8. Press the INPUT key
equipment you have connected to the A/V1 or A/V2 jacks.
Follow the same procedure to connect other compatible video equipment to either
set of A/V jacks.
DVD Player
Back
OUTPUT
VIDEO OUT
VCR TV AUX
POWER
INPUT RESET
1 1 2 2 3 3
Remote Control
IN
FROM ANT.
OUT
OUT TO TV
.
to the TV 75Ω (ohm) terminal.
to Cable Box In.
to VCR Antenna In terminal.
.
. Turn on
external equipment.
to select program source: TV signal or signal from the
S-VIDEO OUT
L R
AUDIO OUT
AUDIO
AUDIO VIDEO INPUT
OUTPUT
AV2 AV1
VIDEO
(MONO)
L
L L
(MONO)
AUDIO
R
R R
VCR Back
A/V JACKS
RF IN
CHANNEL
VIDEO L- AUDIO
CH3 CH4
OUT
VIDEO L- AUDIO
TV Back
UHF/VHF/CATV
75Ω
S-VIDEO
INPUT
IN OUT
-R
-R
.
Splitter
Cable Box Back