Velleman CAMSET14 Guia De Inicio Rapido página 2

Monitor unit
1. image impedance switch
2. handset
3. 4" b/w monitor
4. volume control
5. brightness control
6. contrast control
7. "unlock" LED
8. monitor button
9. intercom button
10. unlock button
11. power LED
1. First install the cable. To connect the camera and monitor units, a 75ohm 5C2V coax cable is recommended.
2. Push the camera unit's screw cover (fig.1 #4) upwards and
remove the (hex) screw under it. Flip the camera unit away
from the rain cover. Now you can also remove the bottom
screw if you want to separate them completely. Pull the wire
through the hole in the rain cover and mount the rain cover
to the wall (see fig. 3). Connect the wire to the camera unit,
flip the camera unit up (or fasten the bottom screw and flip it
up) and fasten it with the top screw. Pull the screw cover down (fig.1 #4).
3. For the monitor unit: pull the wire through the hole in the mounting
bracket and mount the bracket to the wall. Connect the wire to the
monitor unit. Put the monitor unit on the 4 pins on the bracket (fig.4 #1)
and fasten it by means of a screw on either side of the unit (fig.4 #2). Set
the impedance switch of the monitor unit (fig.2 #1) to "75 ".
4. It is possible to connect up to three monitor units to one camera unit,
providing that the total cable length does not exceed 100m. Additional
monitor units are available separately (order code CAMSET14/MON).
Connect the monitor units as in the figure below. The image impedance
switch (fig.2 #1) of the last unit must be set to "75 ", the others to "OFF".
5. Wiring (see fig.5)
You can attach 1,2 or 3 monitor units. If you connect only one monitor
unit, you should switch the impedance matching switch (see fig. 2 #1) of
that unit to "75 ". If you connect two or three monitor units, you should
always switch the impedance matching switch of the last unit in the
series to "75 " (2 monitor units = impedance switch of the second unit, 3
monitor units = impedance switch of the third unit).
6. It is also possible to connect an electronic door lock (not included) to the monitor unit. This can be done by means
of the 2-pin connector (L+ and L-) at the back of the monitor unit. We recommend that no more than 2 monitor
units be connected to an electronic lock (max. cable length 25m).
CAMSET14
Fig.5
Fig.3
2
Fig. 2
Fig.4
VELLEMAN