Motostar LIVIPR Manual De Programación página 3

PROGRAMMING ENTRY PANELS WITH LIVI-AS
Programming for the first time
PROG
M2
M2
SW3
1
2
BOUT
M1
3 B
BOUT
4
BOUT
beep
F
PROG
M2
M2
SW3
G
Entering programming mode
Press the PROG key for at least 3 seconds 1 and then release it (within
PROG
>3''
6 seconds), as soon as the PROG LED lights up and the key back lighting
<6''
flashes as illustrated in figure 2.
SW3
PROG
M1
3
BOUT
M2
Programming Type of Keys
Hold down the first key on the entry panel in the position shown C/
CACB until the back lighting LEDs stop flashing 4 and stay on.
M2
PROG
5
M2
Exiting Programming
Press the PROG key briefly: the PROG LED switches off G.
PROG
<1'' NOTE: If no action is performed, the procedure will end automatically
after 30 minutes.
SW3
3
BOUT
M2
Programming call keys
Press the door release
AUX2
5.
On the entry panel, press the call
key to be linked to the receiver 6:
a beep will confirm that the setting
has been stored.
Continue, repeating the same operations for all the oth-
er receivers.
A M1
M2
buttons at the same time
and