Dry Vacuum Operation - Vacmaster PROFESSIONAL DVTB204 0201 Manual Del Operador

STARTING/STOPPING THE WET/DRY VACUUM
To turn on the wet/dry vacuum, flip the switch to the 'I' ON position. To turn off the wet/dry vacuum,
flip the switch to the 'O' OFF position (Fig. 11).
11

DRY VACUUM OPERATION

WARNING:
ENTITLED 'SAFETY INSTRUCTIONS & WARNINGS'. DO NOT VACUUM IN AREAS
WITH FLAMMABLE GASES, VAPORS, OR EXPLOSIVE DUSTS IN THE AIR. FLAMMABLE
GASES OR VAPORS INCLUDE BUT ARE NOT LIMITED TO: LIGHTER FLUID, SOLVENT
TYPE CLEANERS, OIL-BASED PAINTS, GASOLINE, ALCOHOL, OR AEROSOL SPRAYS.
EXPLOSIVE DUSTS INCLUDE BUT ARE NOT LIMITED TO: COAL, MAGNESIUM, GRAIN, OR
GUN POWDER. TO REDUCE THE RISK OF HEALTH HAZARDS FROM VAPORS OR DUST,
DO NOT VACUUM TOXIC MATERIALS.
12
17
1. Verify that the cartridge filter is securely mounted (Fig. 12). For installation instructions see
page 15.
2. Insert the hose into the vacuum port (Fig. 13).
3. Push required accessories onto the free end of the hose or the extension wand (Fig. 14).
4. Make sure the battery pack is correctly installed (Fig. 15). For installation instructions see page 10.
5. Turn the motor on by flipping the switch to the 'I' ON position (Fig. 16).
6. Once you have completed vacuuming, or when the collection tank is full, turn the motor off by
flipping the switch to the 'O' OFF position (Fig. 17).
7. Remove the battery and place it in the storage bay (Fig. 18).
8. Empty the collection tank into a suitable receptacle (Fig. 19).
BE SURE TO READ, UNDERSTAND, AND APPLY, INFORMATION
13
18
14
19
12
15 16