Overview; Special Product Features; Commissioning; Self-Test - Metabo LC 60 Manual Del Usuario

ENGLISH
ENG
Do not recharge a fully charged battery pack!
Overcharging damages and shortens the life span
of the battery pack!
Only use the charger indoors.
Protect the charger from moisture.
Children should be supervised to ensure that they
do not play with the tool.
Keep children away from the battery charger and
the working area! Keep your battery charger out of
reach of children!
Pull out the mains plug immediately if the battery
charger starts to smoke or flames emerge!
Do not use faulty battery packs.

5 Overview

See page 1.
1 Battery pack *
2 Charging compartment
3 Warning display
4 Operation display
* not in scope of delivery

6 Special Product Features

• Automatic balancing of the individual battery
cells permits optimum utilisation of the available
capacity and, at the same time, lengthens the
service life of the battery pack.

7 Commissioning

Before plugging in, check to see that the
rated mains voltage and mains frequency,
as stated on the rating label, match your
power supply.
7.1

Self-test

Insert mains supply plug.
The warning display (3) and the operating display
(4) light up in succession for approx. 1 second.
6

8 Use

8.1

Charging battery pack

Insert battery pack (1) up to the stop in the
charging compartment (2).
The operating display (4) flashes and the battery is
charged.
When the battery pack is fully charged, the oper-
ating display (4) lights up continuously.
The battery pack can remain in the battery charger
and is therefore always ready for use.

9 Fault

9.1 Warning display (3) lights up
continuously
• Battery pack is not charged. Excessive/Insuffi-
cient temperature. When the temperature of the
battery pack is between 0 °C and 50 °C, the
charging process begins automatically.
9.2

Warning display (3) flashes

• Battery pack is defective. Remove the battery
pack immediately from the charger.
• Short circuit between the charging contacts.
Check the contacts for foreign bodies.

10 Repairs

Repairs to the charger must only be carried out by
qualified electricians.
If the mains connection cable of this tool is
damaged, in order to prevent endangering
personnel and property it must be replaced by the
manufacturer, or the Customer Service of the
manufacturer, or a similarly qualified person.
Metabo chargers requiring repairs can be sent to
the address on the next to the last page. Please
enclose a description of the fault with the power
tool.