GPI GM Serie Guía De Operación página 7

HE Power Supply
4.5 - 24 VDC
(+)
Supply (+)
Signal
Common (–)
GPI
Meter
* Note: Hall Effect requires dedicated power supply.
Input: Reed Switch (See inputs from Diagram 6) or Hall Effect* (See inputs from Diagram 7)
GPI
Meter
* Note: Hall Effect requires dedicated power supply.
W I R I N G D I A G R A M 7
— 4-20 mA or 0-20 mA Output —
Customer Equipment With Built-in Power Supply
Output: Customer Equipment, 0-20 mA Sensing, Built-in Loop Power Supply
INPUTS
(–)
HL-HF IN
Local Com
Pulse Out
EDM Pwr
Black Blue Red
PCB Assembly
W I R I N G D I A G R A M 8
— 4-20 mA or 0-20 mA Output —
Customer Equipment Without Built-in Power Supply
Output: Customer Equipment, 0-20 mA Sensing, Separate Loop Power Supply
INPUTS
GPI
4-20 mA Out
with Display
Input: Hall Effect*
OUTPUTS
Loop (+)
GPI
4-20 mA Out
with Display
Loop (–)
CAUTION:
Loop Power Supply
OUTPUTS Typ 12 - 24 VDC
(+)
Loop (+)
(current)
Loop (–)
(current)
CAUTION:
(current)
Min. V = 8.5
Max. V = 35
(current)
When reassembling the faceplate, make sure that the enclosure
seal is not crimped or twisted. Do not over-tighten corner screws
(hand tighten only). Faceplate can be rotated 90°.
(–)
Customer
Equipment
Loop (–) Input
Min. V = 8.5
Max. V = 35
Loop (+) Input
When reassembling the faceplate, make sure that the enclosure
seal is not crimped or twisted. Do not over-tighten corner screws
(hand tighten only). Faceplate can be rotated 90°.
Customer
Equipment
7