Headrest Adjustment - Balanced Body Allegro 2 Instrucciones

III. ADJUSTING THE
SOFTTOUCH ROPE SYSTEM
AND HEADRESTS
ROPE ADJUSTMENT:
Refer to Arrow A in Figure O. Pull the lever away from the
headrest (Do not push down). The ropes will automatically retract
into the carriage (shorter) or they can be pulled to become
longer. When the desired length is achieved, release the lever and
the ropes will lock. IMPORTANT: Do not use the Reformer with the
lever pulled out in the adjusting position. Doing so can damage
the Reformer.

HEADREST ADJUSTMENT:

Refer to Arrow B in Figure O. Pull the knob away from the
headrest (Do not push down) then lift or lower to the desired
height (flat, medium, or high). When the knob is released the
headrest will lock into position.
Note: The headrest is designed to carry full body weight ONLY
when in the flat position.
A Rope adjustment
Figure O
11
Head rest adjustment
IV. STORAGE
STACKING
Two people are recommended for stacking. The Allegro 2 must
be stacked one on top of the other alternating foot-end and
head-ends as shown in Figure P. The feet of the Reformer lock
onto the standing platform on the foot end and the end casting
on the head end. If you have a standard Allegro 2 you can stack
up to 5 Reformers. If you have an Allegro 2 with extended legs
you can stack up to 3 Reformers . If you have a Tower you cannot
stack the Reformer.
Foot
End
Head
End
Foot
End
Figure P
When stacking, the risers and shoulder rests can be stored under
the head rest of the carriage as shown in Figure Q.
B
Top of Risers
Figure Q
STANDING (wheel kit required)
Transport wheels are an optional kit and must be installed for
standing storage. DO NOT stand the Allegro 2 on end if you
do not have wheels. To install a wheel kit please refer to the
instructions in Allegro 2 Options.
Shoulder
rests