Care And Cleaning - Kohler K-1997 Guía De Instalación Y Cuidado

Offset
Screwdriver
Washer
Screw
5. Secure the Shroud
NOTICE: Risk of product damage. Vitreous material can crack or
chip. Do not overtighten the angle bracket screws.
Carefully position the shroud under the sink.
Partially thread the angle bracket screws. For a snug fit against
the sink, tighten the bottom screw first. Then, use an offset
screwdriver to tighten the top screws. Do not overtighten!
Secure the sink to the wall with the lag bolts and washers.
Tighten until snug. Do not overtighten!

Care and Cleaning

For best results, keep the following in mind when caring for your
KOHLER product:
• Always test your cleaning solution on an inconspicuous area
before applying to the entire surface.
• Wipe surfaces clean and rinse completely with water immediately
after applying cleaner. Rinse and dry any overspray that lands on
nearby surfaces.
• Do not allow cleaners to soak on surfaces.
• Use a soft, dampened sponge or cloth. Never use an abrasive
material such as a brush or scouring pad to clean surfaces.
Kohler Co.
Washer
Lag Bolt
9 1208746-2-A