Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
7
7D
7B
7C
7 SECURING FAUCET
From underneath sink, secure Faucet Body (7A) by placing Metal Washer (7B) and
7
threading Long Nut (
Hex.) (7C) onto Mounting Post (7D). Make sure that the bumps
/
16
on Metal Washer (7B) are facing up. Firmly hand tighten Long Nut (7C). Secure Long
1
Nut (7C) not to exceed a
/
turn.
4
Caution: Do not over tighten!
8
8A
8D
8B
8C
HOT
8 WATER SUPPLY LINES
Gently separate hot and cold Supply Tubes (8A), approximately three inches apart.
Connect water Supply Lines (8C) to Faucet Inlets (8B). Hot water supply line goes to hot
inlet fitting indicated by red tag (8D). (Supply lines not included). Follow manufacturer's
instructions when installing supply lines.
Hold the Faucet Inlets (8B) steady using an adjustable wrench while tightening Supply
Lines (8C). Do not twist Supply Tubes (8A)!
ENGLISH
7A
8A
8B
8C
COLD
3
9
9 POP-UP ROD CONNECTION
Insert Lift Rod (9A) into hole at the back of Faucet Body (9B).
DRAIN BODY INSTALLATION
10
10A
10 POP-UP INSTALLATION
Install and adjust Pop-Up (10A) using separate instructions supplied with the Pop-Up
assembly.
11
11 UNIT START UP
Turn on hot and cold water supplies, and check for leaks above and below the sink.
9A
9B
Publicidad
Tabla de contenido
