Operating Instructions - Intex CS3220 Manual Del Propietário

OPERATION INSTRUCTIONS
1. Turn on the filter pump.
2. Start up the unit:
Plug the power cord into the electrical outlet and test the RCD (circuit
breaker). Press button. Flashing code "00" appears on the electronic
control station's LED, indicating that the unit is ready to be programmed.
3. Set operating hours for Saltwater system:
With code "00" flashing, press
the desired operating hours. See the "Operating
Time Table" for the required operating hours
related to each pool size. Pressing
increase the time from 01 to 12 hours maximum.
If you have selected too many hours keep
pressing to repeat the cycle. The built-in
timer will now activate your Saltwater System, at
the same time each day, for the number of hours you have set.
NOTE: The Saltwater System will not operate if the filter pump is not operating. Make sure
to program your filter pump (or start it manually) for operation beginning 5 minutes before
the saltwater system and finishing 15 minutes after the saltwater system.
4. Lock keypad controls:
With the desired hour value showing, press
"wORKING" indicator on the control panel will light up within a few
seconds to indicate that the saltwater system has started chlorine
production, the LED will display the remaining chlorinator hours until
it's finished. Locking the control buttons into this setting prevents
unauthorized changing of the operating cycle.
NOTE: If you forget to lock the keypad controls, the system will automatically lock it and
start working 10 seconds later.
5. Readjust operating time if necessary:
The operating hours can be re-adjusted if necessary. Press
programmed time will flash. Repeat steps 3 to 4.
6. Stand-by/power saving mode:
• when the cycle ends, the green "SLEEP" indicator on the control
panel lights up and the LED display flashes "93". The system is now
in Stand-By mode. After a while, it shuts down and sets itself in a
Power Saving mode. The system will automatically turn itself back on
in 24 hours, starting its daily cycle of chlorine production.
•
The "SLEEP" indicator stays on, while the system is in the Power
Saving mode. The LED display however, goes blank after 5 minutes.
Press any button (
SAVE THESE INSTRUCTIONS
(133IO) SaltwatEr SyStEm ENGlISH 7.5" X 10.3" PaNtONE 295U 07/21/2020
button to set
will
button. A green
or ) to view the last LED code.
English
(1 to 12 hours max per cycle)
button and the current
Page 11
133
A